Make It Yours: Reversible Curtains Preparation

Standard
A selection of the boring curtains available in local stores.

A selection of the boring curtains available in local stores.

“Make It Yours” is my series of projects you can do to make your house, and yourself and other items that you own, more friendly to your design tastes. At no time am I going to claim that this is cheaper than the alternatives. For example, if you want curtains for your home, it could be cheaper to buy them. However, you are limited to what you can find pre-made. There might be a custom option that is cheaper than making them yourself too.

For me though, it is generally easier if I just make it myself. Maybe, my tastes run a little too esoteric for prime time.

This week, we’ll learn how to make very simple reversible curtains because I like my curtains to look nice from both sides. Nothing fancy here, a novice can complete this project, and you can have them finished within an hour.

You will need:

  • Sewing machine or hand needles
  • Exterior fabric, yardage will be determined
  • Interior fabric, yardage will be determined
  • Thread to match
  • Pins or bulldog clips

First, measure the width of the window, including any additional area of the wall or window frame you want the curtain to cover. You can also measure the length of your current curtain rod to get an idea. Now, measure a second time just to be sure. Add one inch to your measurement. For example, the window I want new curtains for is 34 inches wide, so my first measurement is 35 inches.

Keep in mind that the width measurement is for a single very simple curtain. With these measurements if you make a single curtain, you will not have much in the way of gathering (folds) when you put your curtain up. Many will want a pair of curtains per window. To determine the width each curtain will need to be, you will need to do a little math. Each curtain should be about 75% of your total width. In my example, I would then need a width of 26.25 inches. Or you could just make two full size curtains have a lot of folds – this technique can be very pretty with lightweight fabrics or cumbersome with heavier ones.

Next, measure the length you want your curtains to be. This is up to personal preference. Perhaps, you want a half-curtain with a valance in your kitchen window, or you want a floor length curtain for the living room or you want the curtain to stop at the end of the sill. Decide and measure; measure again. Remember measure twice, cut once. We’ll repeat this mantra over and over again. Add one inch to your measurement. Add additional inches equal to the depth of your curtain rod if you have a rod that bends around the side of the window. In my example, I have 37 inches that I want to cover. So I need 38 inches.

If you don’t have fabric, now is the time to figure out what you will need. The fabric you purchase factors in your width, and you are limited to the stock on hand there. Most fabric at a typical American fabric shop (local quilt shop, JoAnns, etc) come in widths between 36 to 54. You may find some specialty fabrics come in other widths, so this is just in general. The length of your fabric will determine the number of yards you need. If you need help with the inches to yards math and don’t want to use a calculator, there are all kinds of apps that can help. In general though divide your inches by 36. My measurement ends up being 1.06. I round-up to quarter yards, so I need 1.25 yards of each fabric.

Remember to consider, how many curtains you are making as well. Using my example, if I wanted two panels out of each cut I would need a fabric that is at least 52.5 inches wide. If I fall in love with a fabric that is only 44 inches wide, I will need an additional 1.25 yards (for a total of 2.5 yards) to make two curtains.

Once you have your fabric, launder it. Wash it on the highest temperature the fabric can handle and dry it. This should take care of any shrinkage. My method is to wash my fabric on speed wash with about one-quarter to one-half the normal amount of detergent. Do not use fabric softener. I dry my fabric based on what it is. Then, iron your fabric.

In the next post, I will share step-by-step instructions on making your curtains.

Make It Yours: Memory Scarf

Standard

If you sew for any amount of time, you find yourself with scraps. Lots and lots of scraps. You could throw them away, but what’s the fun of that? Besides, it isn’t very earth friendly.

I actually hope for scraps. It is great to see where I have been in my sewing. I relive the projects I have worked on – the ease or difficulty it was to sew with the fabric and such things. I used to keep them in a drawer and look through them every so often in the guise of organizing them. Now, I actually have an idea for true organization of my scraps, and now I can display it! That’s where the Memory Scarf comes in.

Supplies:

  • Scraps, lots of scraps
  • Scissors, rotary cutter, or pinking shears
  • Cardboard square/rectangle measured to a dimension you like. In fact, any shape that you like works. I used 5×5.5 because I had a random rectangle that size.
  • Sewing machine
  • Thread
  • Fray check, optional

First, you’ll want to cut your scraps into a more uniform shape. They don’t have to be uniform, but in the end you will want to be able to see all of your scraps. If you want to use fray check, do that after cutting and before sewing.

scraps

Make the majority of your scraps uniform in size and shape. An odd piece placed every so often can create visual interest.

Next, line up your scraps in a way that is aesthetically pleasing to you. You want to layer them one on top of another at intervals of about an inch.

Sew through your scraps. I sew mine on a diagonal. You want to place each so that at least an inch of every fabric shows. However, you can’t go wrong here. Do what pleases you.

Sew through your scraps, allowing at least an inch of each fabric to show.

Sew through your scraps, allowing at least an inch of each fabric to show.

As for finishing, you aren’t really going to finish it as you will always have new scraps to add. Just add to it. I plan to hang mine from the ceiling of my sewing room, eventually.

Now, it’s your turn. What will you use for your scarf? How will you piece it together?